Masturbation cup cleaning and maintenance of the full strategy

Preface

Recently, many brothers have complained to me that it's the change of season, or they're too lazy, in short, they just don't want to wash the masturbation cup immediately after using it.

The result? The next day, the third day, or even the next time you want to use it again, the cup has already emitted a strange smell and is even moldy. ......

This means that after using the masturbation cup, it is not too much to wash it, right?

So far I have given you the correct cleaning method, but there are still brothers who have stepped on the pit. This time we will concentrate on it.

What exactly do you do if your masturbation cups get moldy?

How do I clean them after a short period of storage?

If it's only overnight, it's not too bad, just rinse it with warm water the next day (except in summer).

Cleaning steps:

• Rinse the inside and outside of the cup with lukewarm water, especially the inside of the channel.
• It is recommended to use a special cleaning solution to enhance the cleaning effect. If not, you can use mild shower gel instead.
• Repeat rinsing several times to ensure thorough cleanliness and no residue.

Tips:

• When stored for a long time, the body fluids inside the channel may solidify, so special attention should be paid to the internal cleaning.
• Brothers who want to reduce the trouble of cleaning, you can choose a high stimulation model masturbation cup, a quick fight and reduce the burden of subsequent cleaning.

Bestvibe Dual Vibrating Eggs 5 Sucking 10 Vibrating Deep Throat Masturbator

£56.99£66.23

View

Cleaning after 2-3 days of storage

After two or three days of storage, the masturbation cups may have become a bit smelly and even begin to harbour bacteria, at which point they must be deep cleaned.

Cleaning Steps:

• Prepare a basin of warm water (do not use boiling water as it may damage the material of the cup).
• Immerse the masturbation cup completely in the water, adding more cleaning solution so that the water completely covers the cup.
• Apply a generous amount of cleaning solution to both the inside and outside of the channel, rubbing the channel with your fingers every few minutes.
• Repeat the cleaning solution application, soaking and rinsing several times until it is completely clean and odorless.

Tips:

• Focus on cleaning the inside of the channel, but don't forget to wash the mouthpiece and outside of the cup!
• The purpose of soaking is to allow the cleaning solution to dissolve the dirt, so don't be in a hurry, soak for a while longer for better results.

Cleaning method for long term storage (mold)

If your masturbation cup has developed black spots and mold, I can only say: throw it away! For the sake of your health, don't hesitate to use it.

But there are always brothers who don't die, who cry and beg me: 'Big Brother, please, I only used it a few times, ah, I really didn't mean to not wash it, I'll be more careful next time!

OK, since you are so reluctant to give up, try to save it.

Cleaning Steps:

• Remove mold stains: Gently wipe mold stains with a damp cloth, soft bristle brush or wet wipes.Internal mold stains can be removed by wrapping a damp cloth around a heating rod or absorbent stick and slowly reaching in to wipe.
• Soak: Refer to the warm water soaking method above and focus on cleaning the inside of the duct.
• Deep cleaning: Clip your fingernails and gently rub the corners of the drain with your fingertips to make sure mold is completely removed.
• Rinse thoroughly: Rinse repeatedly with clean water, especially inside the drain, and rinse against the faucet to allow the water pressure to clean the dead corners.

The Final Step: Sterilization

Whether for short-term or long-term storage, disinfect after cleaning!

Physical Disinfection Methods (Alcohol Disinfection is Prohibited)

Sunlight Disinfection:

• Open the access to the masturbation cup and place it in the sun for 15-20 minutes.
• Do not expose it for a long time, otherwise the cup may deform or shrink.
• Do not expose the cup to the sun for a long time, otherwise the cup may deform or shrink.

Alien - 5 in 1 Automatic Knob Adjusting Male Masturbator Blowjob Toys

£73.99

View

Air Drying: 

• If you are not sure, you can put it in a ventilated place to dry after cleaning to avoid moisture breeding bacteria.

Other cases

If the masturbation cup is due to the improper storage method or left for too long to cause mold, but not the case of long-term storage immediately after use, generally can still be cleaned and continue to use.However, it is still necessary to analyze the specific situation, do not force it!

Special reminder:

After each cleaning, the internal moisture of the channel must be thoroughly absorbed, otherwise it will still be moldy after a long time.

Heaven - 4 in 1 Dual Egg Vibrator Rotating Thrusting Suction sex toys Suction Masturbator

£51.76£78.99

View

How to prevent mold on masturbation cups?

If you don't use your masturbation cup every day, it is recommended to follow the proper care process to preserve it and reduce the risk of mold.

• Thoroughly clean with a cleaning solution
• Make sure no moisture remains inside
• Apply maintenance powder to prevent stickiness
• Store in a dry and ventilated place, avoid humidity.

If you don't use it for a long time, take it out and check it every 2-3 months, clean it and then store it again, which can prolong the service life significantly.

Conclusion

Brothers, masturbation cups must be cleaned in time after use! Do not drag to mold only want to remedy, not only inconvenience, but also affect the health.

If the mold is less, it can still be saved, but if the mold is strong, then don't hesitate to throw it away!

After all, more than a masturbation cup, your little brother is the most important!

-End-